Me and my son build our first motor. Welcome to the jet boat tech page 2. the build up . after getting the housing powder coated black (not shown in pic) it was ready for assembly. i obtained parts from hi-tech performance and used the ultimate wear ring along with a new style packing seal. here is the berk pump that i assembled.. I am planning on making a jet boat from scratch, something similar to a jet dinghy or a jon boat. this would be the first boat i make, i have had 2 small fishing boats before, one of polyester and now one of aluminium, both under 5 meters. i would like to build the boat out of aluminium..
The goal of this project is to design and build an r/c model jet sprint style boat to play around the pond at work. although the pond is probably too small, it is a good visual motivation as i walk past it to get to work every day.. Jet boat!! something different, cheap and fun. jet boat!! something different, cheap and fun. project cars; features. articles but it's turned into a pretty major build so i will continue it here. the plan is for the glassed in jet ski hull to be flush with the bottom of the boat. a short while later.... The average jet drive can build pressures in excess of 150psi and the engine cooling system is designed for no more than a maximum of 22-25psi. excessive water jacket pressures can cause head gasket and intake manifold gasket problems and water in the oil..
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.